Dün gece
@Fickle Willow ile ilgilli baya yazıştık. Durum tespitlerimi bildireyim belki faydası olur. Dün gece bir ara ben de O2-O3 durumuna düştüm. Eski yeni gpon üzerinde çalışırken sök tak yaptım birkaç kez. Bir kaç ayar denedikten sonra eski ayarlarıma geri geldim ama yine aynı durum devam etti. Sonra O5 durumuna geçtim ama vlan bilgileri gelmedi, PPPoE oturumu açamadım ama SFP O5 durumunda idi. Gece gücü kesip bıraktım her şeyi.
Sabah baktım tekrar O2-O3 durumu devam etti. Sonra bir ara O2-O5 arasında gitti geldi. Bu yeni durumu araştırınca sorunun fiber hatta olabileceğine dair bir fikir oluştu. Daha önce O2-O3 için de fiber bağlantı problemi olabiilir şeklinde bir şey daha okuyunca sorunun fiber bağlantı, konnektör ile alakalı olduğuna dair inancım arttı.
- The ONU status changes between O2 and O3.
This problem probably occurs if no PLOAM message is received by the OLT, or CRC errors occur in the received PLOAM messages. The possible causes include ONU exception or poor fiber contact.
- The ONU status changes between O2 and O5.
Check whether the ONU is added to the OLT. You can run the display ont info command on the OLT to check whether the ONU is added. Before an ONU is added, the ONU status keeps changing.
Check the ODN line.
If the optical attenuation is too small, an ONU may go online for a short time and reach the O5 state. However, because the bit error rate is too high, the OLT forces the ONU to go offline after a period of time. You can adjust the optical attenuation to a proper range.
Arayüzden baktığımda optik zayıflamam -23db civarlarında idi. Normalde çalışırken HG8010daki değerler -18, -19 civarında. Gİdip sadece fiber kabloyu çıkardım, hem SPF modüle hem de fiber kabloya şöyle bir üfledim
geri taktım. Hemen O5 durumuna geçti ve zayıflama değerlerim -19 a düştü her zaman ki değerlerine. Sistem daha önce paylaştığım ekran görüntüsündeki ayarlarla sorunsuz bağlandı hemen.
O2 - O3 sorunu yaşayan arkadaşlar acaba hat zayıflama değerlerini paylaşabilir mi?